Chosen Solution
Some drops of liquid came into contact with this SSD after coffee spilled on laptop. Laptop no longer functions, enclosure on the way. A drop was observed around where the arrow is. I merely applied a paper towel to it, several days ago, but didn’t do anything else. I am unsure of what I’m looking at on the boundary between the board and the package. Is it a gap, or sealed with adhesive, or epoxy? Should I try to clean it with isopropyl alcohol, or is it safe to connect to power as is? Would the alcohol damage the package on the side facing up?
I wish you have just given me a flat on picture so I could ID your SSD. Luckly you caught enough of the label that I could read it in your second image! So here is your SSD
And if we where to take off the black label this is what you would see!
I would carefully remove the black cover to expose the solder joints under them so the water or isopropyl alcohol can get to them and I would use an ultrasonic as you need the agitation it offers to get into these tight places.
