Chosen Solution got a 1992 ezgo marathon golf cart you turn the key press on the gas pedal and it just runs, but you pull the choke nob out it will take off and move and only move when choke is being used but will still run die run then die run then die. new fuel pump put on what’s the issue countrygenoch check the carburetor. I would suggest to clean the jets and check the float and needle valve....
Chosen Solution I have replaced the coil distributor all spark plugs and wires fule pump and fule pump fuse relay and even the ECU and it’s still not getting any pules to the injector what do I do ? It’s a 1994 Toyota pickup 4cly 2.4 liter I believe that the sensor in the distributor sends a timing signal to the computer to fire the injectors, so you are saying you have 12 volts at the injectors but the computer is not grounding them to fire them, can you listen to the injectors by putting a long screwdriver against one and listening with your ear up against the handle to tell of they are clicking or not?...
Chosen Solution My beats headphones have just recently been having a strange problem. I will go to plug them in so they can charge, but when I do so it says that they are fully charged. This is strange because then I will go to listen to music(since they are charged) and it says they are dead. You can try to reset your headphones. With nothing plugged into the headphones, press and hold the power button for 10 seconds....
Chosen Solution Im still waiting for my other parts for my computer so i can see if my hdmi plrt is broken. Could some one tell me if it would still work Mike unless we can clearly see the contacts there is no way to say for sure. Looking at the deformity I would think that either the contacts in the port or on the solder connections have gotten damaged too....
Chosen Solution I have a code on my printer that reads paper jam or repair/replace ink. I replaced all ink, checked all paper access points. No jam and full of ink. Code still remains. Any info would be much appreciated.
Chosen Solution I found this mysterious part laying under the control panel on my Kenmore coin operated washer model number 110.27272600. The about an inch and half long. Please help identify what it is. Hi, When you say “….under the control panel…” do you mean that you removed the console panel and found it there or was it lying under the coin box? Are you sure that it belongs in this washer?...
Chosen Solution I have a Mid 2012, 15” MacBook Pro (A1286 - with 820-3330B logic board). The problem is that the macOS can’t read the CPU PECI or CORE TEMPS. The fans are running at full throttle, kernel task reaching 600% and CPU usage is 95%, making the system super slow and unusable. Checked all the sensors using ASD, all sensors read OK, test passed, apart from the TIM test 75%GB test failing which I believe is a false error on these MacBooks....
Chosen Solution hi! i replaced the screen of my iphone 5 and did it really gently, so i didn’t damage anything inside. But after the replacement the home, lock buttons stopped working and also there was no gsm signal. telephone is constantly in recovery mode, but it is possible to bring it from this mode using tinyumbrella, for example. i brought my phone to the best repairment center in town and after 2 days of inspection they said that they couldn’t help....
Chosen Solution aluminum keyboard model A1314 I have tried to turn the battery compartment disc with a screw driver and a coin. It does not budge. Is there a safe way to get it off so I can get the batteries out of the keyboard? You could try a penetrating lubricant like WD-40. I don’t think it would damage anything in the battery compartment as long as you aren’t drowning the thing....
Chosen Solution I have a Vizio E470i-A0. When I power up, the led lights come on for a split second showing the Vizio symbol on the screen, then goes dark and there is nothing. I did the flashlight test and saw nothing. I tested the 0500-0605-0270 power supply and got readings over 140v at led1+ and led2+ leads. Please advise. Thanks irishjfp, Video tutorials links below may help in diagnosing your TV’s issue....
Chosen Solution I need to kno how to open my speaker to fix the charging port! So I opened up my Sharkk because it had water damage, so I was pretty cavalier about it. But it’s actually not that hard if you know how! Remove the back metal grating. This isn’t hard, just use some tweezers and pry it out. Then you’ll have access to six screws. Remove the screws, then the back underpanel comes out....
Chosen Solution I am looking to reset my clover mini POS, i have two and switch POS… not useful anymore. Or, I could sell them. they are new, less than a year I worked with clover for sometime email me. Tony.rivera@seawardpay.com www.SeawardPay.com Good news for a short time we can send you a brand new one with new merchant ID. info@seawardpay.com
Chosen Solution My iPhone 5s had water damaged, blacked out and does not turn on anymore. It has been like this for about 2 month, and now I would like to see if I can repair it myself. I do not know if I need to purchase a new battery. If I have the charger plugged in to my iPhone, and it starts to get hot like its charging, does that mean the battery is still functional?...
Chosen Solution How do I reset my phone Hi, Here’s a link that may help depending on whether you want to do a soft reset or a hard reset. Important: Take note that doing a hard reset will erase all your data and downloaded apps. It will restore the phone to its factory default condition. Be sure to backup the phone to the cloud or a computer before doing this. Also if the phone has a Google (or Samsung) account tied to it you will need to remember the account’s User ID and password to access the phone once it has been reset due to the Google FRP lock (or Samsung account lock) being enabled by the reset....
Chosen Solution My CPU fan is loose and rattling like crazy in it’s casing. I figured out how to open the casing and get to the fan but I can’t tighten it. How do I tighten it? Is it just the bearings and it’s shot? Could be a bad bearing or loose or missing retainer screws. We would need your exact model number to attempt finding the part. These are usually under $20....
Chosen Solution How does the controller knows you actually clicked? because I hit my controller on the desk kinda hard by mistake but now the back trigger is always on like you are physically pressing it non stop. I tried connecting only the battery circuit with the second circuit that have the buttons on it and did not connect the thin circuit that connects to the trigger and I was surprised that it’s still doing the same thing....
Chosen Solution Rear ended a new lookin camry hybrid. Pretty bad impact , the back end was pushed way in so let’s say we’re fixing the entire back end. What do you fellas got for me @usmanq really not a whole lot. There are way to many variables to get you anything exact or even close since we do not know the extend of the damage. First off start by telling us where you are located (Country only) so we have an idea about cost and availability of replacement parts....
Chosen Solution My phone is maxed on memory and now doing all sort of craziness. i am unable to free up the memory and i have tried a direct connection to my computer with no luck. How can I gain access to my phone without losing my information? Hi, Try starting the phone in safe mode and check if that works.
Chosen Solution Trying to put new brake pads and cable on front hand brakes Although there are lots of different types of brakes, changing the cable can often be very similar between them all. You start by loosening the bolt at the brake caliper (the part of the brake that’s closest to the wheel) that holds the inner brake cable. Once the inner brake cable has been loosened at the caliper, you can get enough slack at the brake lever (on the handlebars) to unhook the brake cable from the brake lever....
Chosen Solution there is a fungus in my lens and i want to clean it Hi, I am sorry to say that but fungus in a microscope usually means the death of the microscope. You only Chance is to take it to parts immediately, clean all parts thoroughly and maybe the following might help : Hydrogen peroxide, or bleach, can be used to kill fungus. You might try 94% distilled water, 4% clear ammonia (for cleansing) and 2% hydrogen peroxide Or look for Fungus Cleaning Agent from Carl Zeiss “Fungusreiniger NEU”....
