Posts

Chosen Solution Thank you iFixit for the valuable guide in upgrading my iMac 27 5k 2015 SSD! Unfortunately I seem to have damaged a circuit relevant to the iMac camera. After upgrading the SSD I noticed the camera wasn’t working. Upon inspection in noticed the damage in the circuit on the back of the camera cable connector. Images attached. The cable connector itself is in pristine condition. How could this have happened?...

Chosen Solution My tablet freaked out and started having google play, google+ errors then the whole thing shut off and rebooted only to be stuck on the osculating RCA screen is there a way to reinstall software when you can’t get anywhere will not go to the hard reset. Was wondering if possible to use the sd disk or usb to reinstall software if I can find some for this model....

Chosen Solution My home button is like a tiny bit under the glass and what I can remember 2nd gen home button were supposed to be flat as the bezel? If its working u didn’t screw too tight u may be missing the rubber gasket around the button or the glass on the screen u have may just be a fraction thicker than the original. It might also be not aligned properly where it might stick up a bit on one side and lower on another side…

Chosen Solution May phone stopped working long ago i want to restart it I believe you can hold the “volume up” button and “power” button simultaneously for five seconds. If done correctly, assuming the phone is charged, from there, you should be able to press volume up and down button to enter the boot menu. Try the “reboot” option to see if the phone is still operational so that you may recover pictures, contacts, etcetera, or continue using the phone....

Chosen Solution I need a some help to remove the intake manifold on my 2000 quest. @albert39 attached document is the part of the manual that deals with the intake manifold. Nissan-Quest-Cylinder-head.pdf. Let us know if you need more help.

Chosen Solution Today I got a battery and a screen replacement for my iPhone SE 1st gen and followed instructions to replace both. At the end of the procedure, before pushing the display back in I booted and everything was working fine, the new battery was at 30% and the screen, camera, proximity sensor were all working. I then shut the phone down and pushed the screen in, but it didn’t fit, it was slightly too big and one corner of the frame had a slight dent....

Chosen Solution Any one have any suggestions on how to Repair a screen for a HTC One S? Is the teardown similar to the Google Nexus One or any of the other HTC’s? Thanks! Yes, there is a video on YouTube for this. http://www.youtube.com/watch?v=b0jGY2N2h… Hi, Do we have any instruction to replace the sim tray in HTC one S Thanks How to repair a broken screen in HTC One S?

Chosen Solution So I accidentally waste water on my ps4 and it is a little bit water coming out of the side with the chip on the back and I took it off and the black tape was kinda wet so I cleaned the water off and I’m letting my fan hit it and I’m gonna turn it on different sides please can u help me fix this??? Hi @Jermaine Richardson See the Chosen Solution above Here’s a link to the iFixit Sony PlayStation 4 Repair guide, if this is what you have and not the PS4 Slim

Chosen Solution Hi Is it possible to have my laptop repaired if the Graphics card and/or Mother Board are deemed to be gone, on my MSI GE62 6QD?? Hi, The GPU chip is hard mounted on the motherboard so if it is faulty replacing the chip is very difficult without the proper tools and skills. Here’s an image taken from a video showing the CPU and GPU mounted on the motherboard in a MSI GE62 series laptop...

Chosen Solution Recently my acer Nitro 5 AN515-55-53E5 has had screen flickering. I sent it in to the Acer warehouse and they said it was due to liquid damage. I got it back and cleaned the motherboard with IPA, and it worked for a day, and then it started to glitch again. Are there any other parts that could cause the screen flickering? @kqsmos that looks like you shortened part of the LCD driver board....

Chosen Solution So i asked a question yesterday and today i got to know that it was my iPad 30 pin cable which is bad. can anyone help me with pin layout of positive and negative of the 30 pin connector and not the USB-A side side as i know that. I trued to google but i could not find the + and - Of the pin. if you can, please tell me the Data +ve and data negative too though i dont need it badly....

Chosen Solution I accidentally left my earbuds in my jeans and i washed them. When i charge them the light turns red then green after 1sec. but when i try to turn them on while charging the light turns off. Also when i try to turn them on when they’re not charging the light stays off. Best thing to do is have it dried and remove excess water by using a hair blow dryer, now to further remove moisture you may want to place it inside an airtight container, filled with a bag (small but plenty will do) of silica gels for a few days....

Chosen Solution how do i change the time and date on my fitbit alta? From the Fitbit app dashboard, tap the menu icon in the top left corner and tap Account. Select Settings. Select the option to modify your time zone. Syncing your tracker: Go back to the Account screen and tap your tracker name. Then select Sync.

Chosen Solution i have a 65in uhd tv when i turn it on i get the start screen and then shuts off and the standby light will blink and nothing else unless i unplug it for awhile. i think its the power board it makes a high pitch sound the board has been replaced already anyone kno if or how i can test it? Hi @slick690, Unfortunately I cannot find a free service manual online so unless someone else comes up with a better answer, the best that I can suggest is that you may have to pay for the manual and use it to determine what the problem is....

Chosen Solution I spilled juice on my MacBook and quickly turned it off. I’ve disassembled it, cleaned and assembled it back, but now the display won’t turn on. I know the Mac is turning on due to the trackpad clicking and voice over. This design is much more complicated than older models and I don’t want to take the display out to figure out the LCD connections. Can someone point me to the relevant cables which connect the LCD to the logic board?...

Chosen Solution Hi I have an old Imac lying around and I want to use it as an external HDMi monitor for different devices. I have looked on the internet and some folks have suggested to buy an LCD display driver board. The model number of my IMAC’s native lcd is lm215wf3 sd d1. Can anyone please guide me on this? Will this work? Is it too difficult to do as I don’t have an expertise....

Chosen Solution My charging port is completely gone - any way I can fix the problem with household appliances like paperclips and sewing needles? I don’t think there is a way to fix it by using household appliances, but there are other ways you can fix it. 1.Replace the charging port with a new one. 2.By buying a charging base using it to charge the 3DS.

Chosen Solution How can I get my PC to start up Windows XP again. It just loads the loading screen over and over again until I press F8 and force stop restart. Then the UNmountable Boot Volume message appears. Hi @cdiddles81 Normally for unmountable boot volume, I can think of is the hard disk could be dying. since you mentioned about winxp, chances the hard disk has aged. What is your model of your current pc / laptop?...

Chosen Solution I have an iPhone 8 plus that I bought as a project to fix and get going again, then possibly sell. I have ordered most parts, except for the back glass (hard to find a product red OEM one for a decent price..), and the parts have started arriving now. However, I’ve been doing some reading on the home button. I have the original button, but not the connectors/flex cables....

Chosen Solution How do I get an iPad Version 7 with OS 15.7 into DFU Mode so I can reset it to factory. I do not have the previous owners password and no way of contacting them any longer. Dfu mode? Or recovery mode? If you are just looking to reset the iPad to factory settings then Recovery mode is nearly always sufficient. The way I do it is to power off the iPad....